MAST STEP/CHAIN PLATES

The boat was very carefully leveled. An elaborate square was built to measure the stem and chain plate placement. So this uses the center of the mast step as the center of everything. All the measurements were done several times and holes were drilled.

 

INTERIOR TRIM

I used a teak and holly EVA foam on the cabin sole, built a bilge pump valve system (you can use any of the manual bilge pumps to pump any bilge), installed the electronics and built a circuit breaker on/off box, ran all the wires and plumbing, installed a head and holding tank in the V berth, and a cool storage step in the companionway. 

Head, Holding Tank, Anchor Storage and a cabin sole